ITech IT-M3100 - Output:delay[:Rise] <Nrf; Output:delay:fall <Nrf

Output Commands
Copyright © Itech Electronic Co., Ltd. 8
Returns
NR3
OUTPut:DELay[:RISE] <NRf+>
This command sets the delay time before turning the output on. The function is the
same as the command OUTPut:DELay[:ON] <NRf+>.
Syntax
OUTPut:DELay[:RISE] <NRf+>
Arguments
<0.000-10.000>
Default value
0.000S
Example
OUTP:DEL 1.0
Query command
OUTPut:DELay[:RISE]? [MINimum|MAXimum]
Returns
NR3
OUTPut:DELay:FALL <NRf+>
This command sets the delay time after turning the output off. The function is the same
as the command OUTPut:DELay:OFF <NRf+>.
Syntax
OUTPut:DELay:FALL <NRf+>
Arguments
<0.000-10.000>
Default value
0.000S
Example
OUTP:DEL:FALL 1.0
Query command
OUTPut:DELay:FALL? [MINimum|MAXimum]