IT-M3100 Programming Guide
Copyright © Itech Electronic Co., Ltd. iii
⚫ Never use the instrument with a life-support system or any other equipment
subject to safety requirements.
⚫ Failure to use the instrument as directed by the manufacturer may render
its protective features void.
⚫ Always clean the casing with a dry cloth. Do not clean the internals.
⚫ Make sure the vent hole is always unblocked.
Environmental Conditions
The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument.
20%-80% (non-condensation)
Operating up to 2,000 meters
Note
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
Regulatory Markings
The CE mark indicates that the product
complies with all the relevant European
legal directives. The specific year (if any)
affixed refers to the year when the design
was approved.
The instrument complies with the WEEE
Directive (2002/96/EC) marking
requirement. This affixed product label
indicates that you must not discard the
electrical/electronic product in domestic
household waste.
To Next Page
Loading...
