ITech IT-M3100 - Chapter9 List Commands; List:step:count <NR1; List:step:voltage <Nr1>,<Nrf

List Commands
Copyright © Itech Electronic Co., Ltd. 52
Chapter9 List Commands
LIST:STEP:COUNt <NR1>
This command sets the total steps of the list program.
Syntax
LIST:STEP:COUNt <NR1>
Arguments
<1-100>
Default value
Not applicable
Example
LIST:STEP:COUNt 1
Query command
LIST:STEP:COUNt?
Returns
NR1
LIST:STEP:VOLTage <NR1>,<NRf+>
This command sets the voltage value of the nth step in the list program.
Syntax
LIST:STEP:VOLTage <NR1>,<NRf+>
Arguments
<1-100>,<MINimum-MAXimum|MINimum|MAXimum>
Default value
Not applicable
Example
LIST:STEP:VOLT 1,100.00
Query command
LIST:STEP:VOLTage? <NR1>