Select the memory mode.
Press sub mode memu 【 Set 】 .
Press 【 Repeat size clamp 】 .
Press 【 Number of repeat size 】 .
The number of repeat size mark is displayed in the function field.
Position the backgauge with the repeat size function and lower clamp only to clamp.
Enter the repeat size for clamping, using the ten-key pad.
The clamp repeat size mark is displayed in the function field.
Use the ten-key pad, enter the frequency.
How to use clamping repeat size function to expel air
In case of the memory mode, even if the displayed page data is clamped, the press of
thecutting buton cause to move the clamp and knife.
Be careful about knife operation buton, there is a risk of injury.
The repeat size frequency may not be entered on page 1.
Enter from 1 to 999.
Entry is unnecessary incase of 1.
Enter " ０ " to designate frequency.
To Next Page
Loading...
