bolt. If breakage is confirmed, turn the machine off and take measures to keep out the area
The machine with a broken safety bolt is stopped in an extremely unstable and dangerous
state. Replacement accompanies much danger and needs professional knowledge.
ITOTEC's trained engineer will conduct replacemant.
If an excessive load is added to the knife or knife carrier, the safety bolt becomes loose or
it is broken, causing an emergency stop to the knife. An alarm is displayed on the message
window of the touch panel display at this time.
Visual confirmation may be impossible even if the safety bolt is loose. Retighten the safety
against entry of a third party and contact the nearest service center or our service division.
Never reach beneath the knife.
Otherwise injuries will be caused.
Do not pull out the product.
Otherwise injuries will be caused with the cutting edge of the knife or the like.
To Next Page
Loading...
