Turn the vertical adjusting screw counterclockwise by the amount of the error.
Adjust so that the guide roller makes light contact with the surface plate.
Using the backgauge comb adjusting screw, adjust the gap between the front end of the
backgauge comb and surface plate.
Vertical adjustment of the backgauge 1
Turn the backgauge comb adjusting screw clockwise to widen the gap. Turn
counterclockwise so that the backgauge comb is pushed down, to narrow the gap.
The gap should be adjusted so that the product does not enter the gap.
Adjust to the best clamp pressure.
If the bottom layer is cut larger : Reduce the pressure.
If the upper layer is cut larger : Increase the pressure.
If warp is caused to the cutting edge, the bottom layer is cut larger.
Grind to correct.
Vertical difference and other essential point
To Next Page
Loading...
