Itotec SC115Z - Page 61

5
Message Remedy
① Inspect the safety bolt and support
bolt.
Message Remedy
The PLC battery voltage is low. ① Contact our service division.
Message Remedy
A count alarm of the clamp height ① Contact our service division.
sensor is detected.
◆
Message Remedy
The timing of periodic inspection is ① Contact our service division.
reaches. ( Arbitrary setting )
Message Remedy
Reminder of oil replacement timing. ① Contact our service division.
( Arbitrary setting )
Message Remedy
① Replace the knife.
( Arbitrary setting )
Maintenance
Other message views
Cutting is interrupted due to a broken
safety bolt or loose knifesupport bolt.
Reminder of knife replacement timing.
Alarm and remedy 2
5.
6.
If this alarm is caused during knife operation , the cutting edge of the knife may be
stopped at a position lower than the bottom face of the clamp. A message and a
buzzer notify.
Do not reach beneath the knife.
8.
7.
10.
9.
CAUTION
61