Juniper EX3400

<in minutes>
<local>
<media (external | internal)>
<member member-id>
<message "text">
<other-routing-engine>
Release Information Command introduced before Junos OS Release 7.4.
Option other-routing-engine introduced in Junos OS Release 8.0.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Option sfc introduced for the TX Matrix Plus router in Junos OS Release 9.6.
Option both-routing-engines introduced in Junos OS Release 12.1.
Description Reboot the software.
NOTE: Starting with Junos OS Release 15.1F3, the statement request system
reboot reboots only the guest operating system on the PTX5000 with
RE-PTX-X8-64G and, MX240, MX480, and MX960 with RE-S-X6-64G.
Starting with Junos OS Release 15.1F5, the statement request system reboot
reboots only the guest operating system on the MX2010, and MX2020 with
REMX2K-X8-64G.
Options none—Reboot the software immediately.
all-chassis—(TX Matrix routers and TX Matrix Plus routers only) (Optional) On a TX
Matrix router or TX Matrix Plus router, reboot all routers connected to the TX Matrix
or TX Matrix Plus router, respectively.
all-lcc—(TX Matrix routers andTX Matrix Plus routers only) (Optional) On a TX Matrix
router or TX Matrix Plus router, reboot all line card chassis connected to the TX Matrix
or TX Matrix Plus router, respectively.
all-members—(EX4200 switches and MX Series routers only) (Optional) Reboot the
software on all members of the Virtual Chassis configuration.
at time—(Optional) Time at which to reboot the software, specified in one of the following
ways:
• now—Stop or reboot the software immediately. This is the default.
• +minutes—Number of minutes from now to reboot the software.
• yymmddhhmm—Absolute time at which to reboot the software, specified as year,
month, day, hour, and minute.
• hh:mm—Absolute time on the current day at which to stop the software, specified
in 24-hour time.
367Copyright © 2017, Juniper Networks, Inc.
Chapter 14: Operational Commands (DHCP and DHCP Relay)