Juniper EX3400

Required Privilege
Level
view
Related
Documentation
Clearing DHCP Bindings for Subscriber Access•
• Verifying and Managing Agent Circuit Identifier-Based Dynamic VLAN Configuration
• clear dhcp server binding on page 342
List of Sample Output show dhcp server binding on page 382
show dhcp server binding detail on page 382
show dhcp server binding detail (ACI Interface Set Configured) on page 383
show dhcp server binding interface <vlan-id> on page 383
show dhcp server binding interface <svlan-id> on page 383
show dhcp server binding <ip-address> on page 383
show dhcp server binding <session-id> on page 384
show dhcp server binding summary on page 384
show dhcp server binding <interfaces-vlan> on page 384
show dhcp server binding <interfaces-wildcard> on page 384
Output Fields Table 18 on page 379 lists the output fields for the show dhcp server binding command.
Output fields are listed in the approximate order in which they appear.
Table 18: show dhcp server binding Output Fields
Level of OutputField DescriptionField Name
summarySummary counts of the total number of DHCP clients and
the number of DHCP clients in each state.
number clients,
(number init,
number bound,
number selecting,
number requesting,
number renewing,
number releasing)
brief
detail
IP address of the DHCP client.IP address
brief
detail
Session ID of the subscriber session.Session Id
brief
detail
Hardware address of the DHCP client.Hardware address
brief
detail
Number of seconds in which lease expires.Expires
379Copyright © 2017, Juniper Networks, Inc.
Chapter 14: Operational Commands (DHCP and DHCP Relay)