show dhcpv6 server binding
Syntax show dhcpv6 server binding
<address>
<brief | detail | summary>
<interface interface-name>
<interfaces-vlan>
<interfaces-wildcard>
<logical-system logical-system-name>
<routing-instance routing-instance-name>
Release Information Command introduced in Junos OS Release 9.6.
Options interfaces-vlan and interfaces-wildcard added in Junos OS Release 12.1.
Description Display the address bindings in the client table on the extended Dynamic Host
Configuration Protocol for IPv6 (DHCPv6) local server.
Options address—(Optional) One of the following identifiers for the DHCPv6 client whose binding
state you want to show:
• CID—The specified Client ID (CID).
• ipv6-prefix—The specified IPv6 prefix.
• session-id—The specified session ID.
brief | detail | summary—(Optional) Display the specified level of output about active
client bindings. The default is brief, which produces the same output as show dhcpv6
server binding.
interface interface-name—(Optional) Display information about active client bindings
on the specified interface. You can optionally filter on VLAN ID and SVLAN ID.
interfaces-vlan—(Optional) Interface VLAN ID or S-VLAN ID interface on which to show
binding state information.
interfaces-wildcard—(Optional) Set of interfaces on which to show binding state
information. This option supports the use of the wildcard character (*).
logical-system logical-system-name—(Optional) Display information about active client
bindings for DHCPv6 clients on the specified logical system.
routing-instance routing-instance-name—(Optional) Display information about active
client bindings for DHCPv6 clients on the specified routing instance.
Required Privilege
Level
view
401Copyright © 2017, Juniper Networks, Inc.
Chapter 14: Operational Commands (DHCP and DHCP Relay)