• ldp—Label Distribution Protocol
• l2circuit—Layer 2 circuit
• l2vpn—Layer 2 virtual private network
• local—Local address
• mpls—Multiprotocol Label Switching
• msdp—Multicast Source Discovery Protocol
• ospf—Open Shortest Path First versions 2 and 3
• ospf2—Open Shortest Path First versions 2 only
• ospf3—Open Shortest Path First version 3 only
• pim—Protocol Independent Multicast
• rip—Routing Information Protocol
• ripng—Routing Information Protocol next generation
• rsvp—Resource Reservation Protocol
• rtarget—Local route target virtual private network
• static—Statically defined route
• tunnel—Dynamic tunnel
• vpn—Virtual private network
NOTE: EX Series switches run a subset of these protocols. See the switch
CLI for details.
Required Privilege
Level
view
List of Sample Output show route protocol access on page 434
show route protocol access-internal extensive on page 434
show route protocol arp on page 434
show route protocol bgp on page 435
show route protocol bgp detail on page 435
show route protocol bgp detail (Labeled Unicast) on page 435
show route protocol bgp extensive on page 436
show route protocol bgp terse on page 437
show route protocol direct on page 437
show route protocol frr on page 438
show route protocol l2circuit detail on page 438
show route protocol l2vpn extensive on page 439
show route protocol ldp on page 440
433Copyright © 2017, Juniper Networks, Inc.
Chapter 14: Operational Commands (DHCP and DHCP Relay)
To Next Page
Loading...
