• Canada—Canadian Electrical Code, Part 1, CSA C22.1.
• Suitable for installaon in Informaon Technology Rooms in accordance with Arcle 645 of the
Naonal Electrical Code and NFPA 75.
Peut être installé dans des salles de matériel de traitement de l’informaon conformément à
l’arcle 645 du Naonal Electrical Code et à la NFPA 75.
• Locate the emergency power-o switch for the room in which you are working so that if an electrical
accident occurs, you can quickly turn o the power.
• Make sure that you clean grounding surface and give them a bright nish before making grounding
connecons.
• Do not work alone if potenally hazardous condions exist anywhere in your workspace.
• Never assume that power is disconnected from a circuit. Always check the circuit before starng to
work.
• Carefully look for possible hazards in your work area, such as moist oors, ungrounded power
extension cords, and missing safety grounds.
• Operate the device within marked electrical rangs and product usage instrucons.
• To ensure that the device and peripheral equipment funcon safely and correctly, use the cables and
connectors specied for the aached peripheral equipment, and make certain they are in good
condion.
You can remove and replace many device components without powering o or disconnecng power to
the device, as detailed elsewhere in the hardware documentaon for this device. Never install
equipment that appears to be damaged.
Acon to Take Aer an Electrical Accident
If an electrical accident results in an injury, take the following acons in this order:
1. Use cauon. Be aware of potenally hazardous condions that could cause further injury.
2. Disconnect power from the device.
3. If possible, send another person to get medical aid. Otherwise, assess the condion of the vicm, and
then call for help.
161
To Next Page
Loading...
Need help?
General
