Locang the Serial Number on an EX4600 Switch or Component
IN THIS SECTION
Lisng the Chassis and Component Details Using the CLI | 129
Locang the Chassis Serial Number ID Label on an EX4600 Switch | 131
Locang the Serial Number ID Labels on FRU Components | 131
If you are returning a switch or component to Juniper Networks for repair or replacement, you must
locate the serial number of the switch or component. You must provide the serial number to the Juniper
Networks Technical Assistance Center (JTAC) when you contact them to obtain a Return Materials
Authorizaon (RMA). See
Contact Customer Support to Obtain Return Material Authorizaon
.
If the switch is operaonal and you can access the command-line interface (CLI), you can list serial
numbers for the switch and for some components with a CLI command. If you do not have access to the
CLI or if the serial number for the component does not appear in the command output, you can locate
the serial number ID label on the switch or component.
NOTE: If you want to nd the serial number ID label on a component, you need to remove the
component from the switch chassis, for which you must have the required parts and tools
available.
Lisng the Chassis and Component Details Using the CLI
To list the EX4600 switch and components and their serial numbers, use the show chassis hardware CLI
operaonal mode command.
user@device> show chassis hardware
{master:0}
root@RIDGE_IEEE> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis TC3113520021 EX4600-40F
Pseudo CB 0
Routing Engine 0 BUILTIN BUILTIN EX4600-40F
FPC 0 REV 11 650-049940 TC3113520021 EX4600-40F
129
To Next Page
Loading...
Need help?
General
