Table 27: Cable Specicaons for Console and Management Connecons for the QFX Series
(Connued)
Port on QFX Series
Device
Cable Specicaon Cable Supplied Maximum Length Device
Receptacle
Management port Category 5 cable or
equivalent suitable for
1000BASE-T operaon
One 7-foot (2.13-meter)
length RJ-45 patch cable
328 feet
(100 meters)
RJ-45
USB Port Specicaons for an EX Series Switch
Juniper Networks tested and ocially supports the following USB ash drives for the USB port on all
EX Series switches:
• RE-USB-1G-S
• RE-USB-2G-S
• RE-USB-4G-S
CAUTION: Any USB memory product not listed as supported for EX Series switches
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your EX Series switch to unpredictable behavior. Juniper
Networks Technical Assistance Center (JTAC) can provide only limited support for
issues related to unsupported hardware. We strongly recommend that you use only
supported USB ash drives.
All USB ash drives used on EX Series switches must have the following features:
• USB 2.0 or later.
• Formaed with a FAT or MS-DOS le system.
• If the switch is running Junos OS Release 9.5 or earlier, the formang method must use a primary
boot record. Microso Windows formang, by default, does not use a primary boot record. See the
documentaon for your USB ash drive for informaon about how your USB ash drive is formaed.
67