Juniper EX4600

Table 6: Chassis Status LEDs on an EX4600 Switch (Connued)
Name Color State Descripon
ID (Idencaon) Unlit O The beacon feature is not enabled
on the switch. This feature is
enabled using the request chassis
beacon command.
Blue Blinking The beacon feature is enabled on
the switch. This feature is enabled
using the request chassis beacon
command.
SEE ALSO
show chassis alarms
request chassis beacon
Expansion Modules for the EX4600
IN THIS SECTION
EX4600-EM-8F | 19
QFX-EM-4Q | 20
The EX4600 switch has two bays on the port panel in which you can oponally install one or two
expansion modules. The EX4600 supports the same two expansion modules as the QFX5100, which
increase port density:
• EX4600-EM-8F, which provides 8 addional 10-Gigabit Ethernet Enhanced Small Form-Factor
Pluggable (SFP+) ports.
• QFX-EM-4Q, which provides 4 addional 40-Gigabit Quad SFP+ (QSFP+) ports.
18