Juniper M120 - RJ-45 Connector Pinouts for the External Clock Ports; Management Cable and Transceiver Specifications and Pinouts; Table 62: RJ-45 Connector Pinout for the External Interface Ports

Table 61: RJ-45 Connector Pinout for the Routing Engine AUX and CONSOLE
Ports (continued)
DescriptionSignalPin
Transmit DataTXD3
Signal GroundGround4
Signal GroundGround5
Receive DataRXD6
Data Set ReadyDSR/DCD7
Clear to SendCTS8
Related
Documentation
Replacing the Console or Auxiliary Cable on the M120 Routing Engine on page 207•
• Maintaining M120 PICs and PIC Cables on page 275
• Installing an M120 PIC Cable on page 229
• M120 PICs Description on page 57
RJ-45 Connector Pinouts for the External Clock Ports
The External Interface clock connector uses an RJ-45 connector. Table 62 on page 107
describes the pinouts for the RJ-45 connector.
Table 62: RJ-45 Connector Pinout for the External Interface Ports
SignalPin
Receive — Ring1
Receive + TIP2
Not used3
Transmit — ring4
Transmit + TIP5
Not connected6
Not connected7
Not connected8
107Copyright © 2018, Juniper Networks, Inc.
Chapter 13: Management Cable and Transceiver Specifications and Pinouts