Juniper M120 - Connecting the M120 Router to a Network for Out-Of-Band Management; Figure 50: M120 Routing Engine Management Ports and Alarm Relay

Figure 50: M120 Routing Engine Management Ports and Alarm Relay Contacts
Connecting the M120 Router to a Network for Out-of-Band Management
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the ETHERNET port on the craft interface. One
such cable is provided with the router. For cable specifications, see “Routing Engine
Interface Cable and Wire Specifications for the M120 Router” on page 105. To connect the
Routing Engine to a network for out-of-band management:
1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable (Figure 51 on page 157 shows the connector) into
the appropriate ETHERNET port on the CIP. Figure 52 on page 157 shows the external
device ports on the CIP. The ports labeled HOST 0 connect to the Routing Engine in
the upper Routing Engine slot (RE 0), and the ports labeled HOST 1 connect to the
Routing Engine in the lower Routing Engine slot (RE 1).
Copyright © 2018, Juniper Networks, Inc.156
M120 Multiservice Edge Router Hardware Guide