connect the router to external alarm-reporting devices through the alarm relay contacts
on the CIP. (For more information, see “M120 Craft Interface Description” on page 11.)
After you have installed the router into the rack, attach one or more external devices to
the ports on the CIP that connect to the Routing Engines for management and service
operations (see Figure 48 on page 154). For specifications for the cable accepted by the
Routing Engine management ports, see “Routing Engine Interface Cable and Wire
Specifications for the M120 Router” on page 105.
Figure 48: M120 Routing Engine Management Ports and Alarm Relay Contacts
•
Connecting the M120 Router to a Management Console or Auxiliary Device on page 155
•
Connecting the M120 Router to a Network for Out-of-Band Management on page 156
•
Connecting the M120 Router to an External Alarm-Reporting Device on page 158
Copyright © 2018, Juniper Networks, Inc.154
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
