1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to an approved site ESD grounding point. See the instructions for your site.
3. Pull the lower end of the ejector lever away from the CFPC faceplate to unseat the
CFPC.
4. Continue to pull the lever toward you and slide the CFPC straight out of the card cage
halfway.
5. Place one hand around the front of the CFPC and the other hand under it to support
it. Slide the CFPC completely out of the chassis, and place it on the antistatic mat or
in the electrostatic bag.
CAUTION: Whenthe CFPC is out of the chassis, do not holdit by the ejector
handle, bus bars, or edge connectors. They cannot support its weight.
Place each individual CFPC in an individual electrostatic bag or on its own
antistatic mat on a flat, stable surface.
Figure 39: Removing a CFPC Before Installing the M120 Router
Copyright © 2018, Juniper Networks, Inc.138
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
