Installation Safety Warnings for Juniper Networks Devices
Observe the following warnings before and during hardware equipment installation:
•
Intrabuilding Ports Warning on page 322
•
Installation Instructions Warning on page 322
•
Rack-Mounting Requirements and Warnings on page 323
•
Ramp Warning on page 326
Intrabuilding Ports Warning
WARNING: The intrabuilding ports of the equipment or subassembly are
suitable for connection to intrabuilding or unexposed wiring or cabling only.
The intrabuilding ports of the equipment or subassembly MUST NOT be
metallicallyconnected to interfacesthat connect to the Outside Plant (OSP)
or its wiring. These interfaces are designed for use as intrabuilding interfaces
only (Type 2 or Type 4 ports as described in GR-1089) and require isolation
from the exposed OSP cabling. The addition of Primary Protectors is not
sufficient protection in order to connect these interfaces metallically to OSP
wiring.
Installation Instructions Warning
WARNING: Read the installation instructions before you connectthe hardware
equipment to a power source.
Waarschuwing Raadpleeg de installatie-aanwijzingenvoordatuhet systeem
met de voeding verbindt.
Varoitus Lue asennusohjeet ennen järjestelmän yhdistämistä virtalähteeseen.
Attention Avant de brancherlesystème sur la source d'alimentation, consulter
les directives d'installation.
Warnung Lesen Sie die Installationsanweisungen, bevor Sie das System an
die Stromquelle anschließen.
Avvertenza Consultare leistruzioni di installazione prima di collegare il sistema
all'alimentatore.
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte
de energia.
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Copyright © 2018, Juniper Networks, Inc.322
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
