Figure 46: Reinstalling a Front Fan Tray After Installing the M120 Router
Reinstalling the Cable Management System
To reinstall the cable management system:
1. Position the cable management system on the studs on the lower front of the chassis.
2. Insert the nuts on the corners in the cable management system onto the studs on the
chassis.
3. Using a 3/8-in. nut driver, tighten the nuts securely.
Related
Documentation
• M120 Router Chassis Description on page 7
• M120 Router Installation Summary on page 111
• Removing Components from the Chassis Before Installing the M120 Router Without a
Mechanical Lift on page 129
149Copyright © 2018, Juniper Networks, Inc.
Chapter 18: Installing the M120 Without a Mechanical Lift
To Next Page
Loading...
