CHAPTER 18
Installing the M120 Without a Mechanical
Lift
•
Tools and Parts Required to Install the M120 Router Without a Mechanical
Lift on page 129
•
Removing Components from the Chassis Before Installing the M120 Router Without a
Mechanical Lift on page 129
•
Installing the M120 Router Without Using a Mechanical Lift on page 139
•
Reinstalling Components in the Chassis After Installing the M120 Router Without a
Mechanical Lift on page 142
Tools and Parts Required to Install the M120 Router Without a Mechanical Lift
To install the router, you need the following tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
3/8-in. nut driver
•
ESD grounding wrist strap
Related
Documentation
M120 Router Chassis Description on page 7•
• M120 Router Installation Summary on page 111
• M120 Chassis Lifting Guidelines on page 321
• General Safety Warnings for Juniper Networks Devices on page 314
• Removing Components from the Chassis Before Installing the M120 Router Without a
Mechanical Lift on page 129
Removing Components from the Chassis Before Installing the M120 Router Without
a Mechanical Lift
To make the router light enough to install manually, you first remove most components
from the chassis. The procedures in this section for removing components from the
chassis are for initial installation only, and assume that you have not connected power
129Copyright © 2018, Juniper Networks, Inc.
To Next Page
Loading...
