The following drive has been verified to work in the RE-1800 Routing Engines:
•
SSD SLC 32 GB
To replace a storage drive:
1. Disable and deactivate the storage drive.
2. Remove the storage drive.
a. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to an ESD point on the appliance.
For more information about ESD, see Prevention of Electrostatic Discharge Damage
on VXA Series Content Engines.
b. Unfasten the thumbscrew that secures the access door in front of the storage drive
slots, and open the door.
c. Slide the lock on the ejector to the unlocked position.
d. Carefully slide the drive out of the slot.
3. Reinstall a storage drive.
a. Carefully align the sides of the drive with the guides in the slot.
b. Slide the drive into the slot until you feel resistance, carefully ensuring that it is
correctly aligned.
c. Close the access door and tighten the thumbscrew to secure the door.
4. Mount the new storage drive.
Related
Documentation
Returning a Hardware Component to Juniper Networks, Inc. on page 305•
Replacing a DIMM Module in M120 Routing Engines
1.
Removing a M120 DIMM Module on page 200
2.
Installing a M120 DIMM Module on page 201
Removing a M120 DIMM Module
The DIMM modules are located on the top of the Routing Engine. To remove a DIMM
module:
Copyright © 2018, Juniper Networks, Inc.200
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
