Juniper M120 - Figure 91: Connecting Fiber-Optic Cable to an M120 PIC

6. Repeat the previous steps for any additional cables.
7. If the PIC is offline (its failure indicator LED is lit), use one of the following methods
to bring the PIC online:
•
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in an FPC1, use a tool—such as a flat-blade screwdriver—to press the button slightly
beneath the faceplate of the PIC. For a PIC installed in an FPC2 or FPC3, use a
narrow-ended tool that fits inside the opening that leads to the button.
•
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the CLI Explorer.
The normal functioning indicator LED confirms that the PIC is online. You can also
verify correct PIC functioning by issuing the show chassis fpc pic-status command
described in “Maintaining M120 PICs and PIC Cables” on page 275.
Figure 91: Connecting Fiber-Optic Cable to an M120 PIC
See Also M120 PICs Description on page 57•
• Connecting PIC Cables to the M120 Router on page 164
• Maintaining M120 PICs and PIC Cables on page 275
• Removing an M120 PIC Cable on page 228
Copyright © 2018, Juniper Networks, Inc.230
M120 Multiservice Edge Router Hardware Guide