Figure 73: Installing the DIMM Module
See Also M120 Routing Engine Description on page 22•
• Replacing an M120 Routing Engine on page 195
• Removing a M120 DIMM Module on page 200
Related
Documentation
M120 Routing Engine Description on page 22•
• Replacing an M120 Routing Engine on page 195
Replacing an M120 CB
To replace a CB, perform the following procedures:
•
Removing an M120 CB on page 202
•
Installing an M120 CB on page 204
Removing an M120 CB
The router can have one or two CBs. They are located on either side of the FEBs in the
rear of the chassis in the slots marked CB0 and CB1. With an RE installed, each CB weighs
approximately 6.9 lb (3.1 kg).
Copyright © 2018, Juniper Networks, Inc.202
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
