CAUTION: Failure tohandleFPCsasspecifiedcancauseirreparable damage.
When carrying an FPC, you can hold it either vertically or horizontally.
NOTE: An FPC configured with four PICs weighs 12.3 lb (5.6 kg). Be prepared
to accept the full weight of the FPC as you lift it.
You hold an FPC vertically when installing it into the chassis or an equipment rack. If the
FPC is vertical before you grasp it (for example, if it is installed in a router), you can place
either hand around the faceplate and your other hand under the bottom edge.
To hold an FPC vertically (see Figure 104 on page 272):
1. Orient the FPC so that the faceplate faces you. To verify orientation, confirm that the
text on the FPC is right-side up and that the EMI strips are facing up.
2. Place one hand around the FPC faceplate about a quarter of the way down from the
top edge. To avoid deforming the electromagnetic interference (EMI) shielding strip,
do not press hard on it.
3. Place your other hand at the bottom edge of the FPC.
Figure 104: Holding an M120 FPC Vertically
Copyright © 2018, Juniper Networks, Inc.272
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
