Juniper M120 - Connecting the M120 to External Devices; Tools and Parts Required to Connect the M120 Router; Connecting the M120 Router to Management and Alarm Devices

installing the router in an open-frame rack, install a mounting screw into each of the
open mounting holes aligned with the rack, starting from the bottom.
9. Visually inspect the alignment of the router. If the router is installed properly in the
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.
Figure 31: Installing the M120 Router in the Rack
NOTE: This illustration depicts the router being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post
rack or cabinet, see Figure 29 on page 121.
Related
Documentation
• M120 Router Chassis Description on page 7
• M120 Router Physical Specifications on page 82
• General Safety Warnings for Juniper Networks Devices on page 314
• General Safety Guidelines for Juniper Networks Devices on page 313
127Copyright © 2018, Juniper Networks, Inc.
Chapter 17: Installing the M120 With a Mechanical Lift