CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Figure 102: Removing an M120 FEB
See Also M120 Forwarding Engine Boards (FEBs) Description on page 75•
• M120 Forwarding Engine Boards (FEBs) LEDs on page 77
• Maintaining the M120 FEBs on page 278
• Troubleshooting M120 FEBs on page 289
• Installing an M120 FEB on page 256
Installing an M120 FEB
To install a FEB (see Figure 103 on page 257):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Place one hand underneath the FEB to support it. With the other hand, hold one of
the ejector handles on the FEB faceplate.
Copyright © 2018, Juniper Networks, Inc.256
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
