Juniper M120 - Figure 64: Installing the M120 Front Air Filter

3. While pushing the air filter straight back into the chassis, lift the front edge of the air
filter to secure it under the hooks.
4. Reinstall the air filter faceplate onto the chassis, and fasten the captive screws on
both sides.
5. Lower the cable management system back into position.
6. Rearrange the PIC cables in the cable management system. For more information
about proper cable arrangement, see “Maintaining M120 PICs and PIC Cables” on
page 275.
Figure 64: Installing the M120 Front Air Filter
See Also M120 Cooling System Description on page 19•
• Maintaining the M120 Air Filter on page 263
• Troubleshooting the M120 Cooling System on page 286
• Removing the M120 Air Filter on page 187
Related
Documentation
M120 Cooling System Description on page 19•
189Copyright © 2018, Juniper Networks, Inc.
Chapter 25: Replacing Cooling System Components