Do not stack FPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
9. If necessary, remove each installed PIC from the FPC. For information on removing a
PIC, see “Removing an M120 PIC” on page 223.
10. After you remove each PIC, immediately place it on an antistatic mat or in an
electrostatic bag.
11. If you are not reinstalling a FPC into the emptied FPC slot within a short time, install
a blank FPC panel over the slot to maintain proper airflow in the FPC card cage.
CAUTION: After removing an FPC from the chassis, wait at least 30
seconds before reinserting it, removing an FPC from a different slot, or
inserting an FPC into a different slot.
Figure 84: Removing an M120 FPC
215Copyright © 2018, Juniper Networks, Inc.
Chapter 27: Replacing Line Card Components
To Next Page
Loading...
