Juniper M120 - Replacing Chassis Components; Replacing Alarm Relay Wires on the M120 Craft Interface

3. Plug the other end of the cable into the network device.
Figure 51: M120 Routing Engine Ethernet Cable Connector
Figure 52: M120 Routing Engine External Device Ports
See Also M120 Power Supplies Description on page 71•
• Connecting the Grounding Cable to the M120 Router on page 151
• Powering On the M120 Router on page 170
• General Electrical Safety Warnings for Juniper Networks Devices on page 339
157Copyright © 2018, Juniper Networks, Inc.
Chapter 20: Connecting the M120 to External Devices