1. On the rear of each rack rail, partially insert a mounting screw into the highest hole
specified in Table 66 on page 121 for the large shelf.
2. Install the large shelf on the rack. Hang the shelf over the mounting screws using the
keyhole slots located near the top of the large shelf flanges.
3. Partially insert screws into the open holes in the ears of the large shelf.
4. Tighten all the screws completely.
Related
Documentation
• M120 Rack Mounting Requirements on page 83
• M120 Site Preparation Checklist on page 81
• Installation Safety Warnings for Juniper Networks Devices on page 322
Copyright © 2018, Juniper Networks, Inc.124
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
