Wait until a message appears on the console confirming that the operating system
has halted. For more information about the command, see the CLI Explorer.
2. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
3. Switch the circuit breaker on each DC power supply faceplate to the off position (O).
For the AC power supply, move the power switch to the standby position.
Related
Documentation
• General Electrical Safety Warnings for Juniper Networks Devices on page 339
• M120 AC Power Supply Description on page 72
• Powering On the M120 Router on page 170
Copyright © 2018, Juniper Networks, Inc.172
M120 Multiservice Edge Router Hardware Guide
To Next Page
Loading...
