Juniper SRX300 Series - Maintaining the SRX Series Interface Modules; Required Tools and Parts for Replacing Interface Modules

Maintaining the SRX Series Interface Modules
IN THIS SECTION
Required Tools and Parts for Replacing Interface Modules | 129
Preventing Electrostatic Discharge Damage to the SRX300 Series and SRX550 High Memory Services
Gateway | 130
Replacing Mini-Physical Interface Modules on the SRX300 Series and SRX550 High Memory Services
Gateways | 131
Replacing Gigabit-Backplane Physical Interface Modules on the SRX300 Series and SRX550 High Memory
Services Gateways | 134
Required Tools and Parts for Replacing Interface Modules
The following tools and parts are required for replacing a Gigabit-Backplane Physical Interface Module
(GPIM) or a Mini-Physical Interface Module on the services gateway:
•
Electrostatic bag or antistatic mat, for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade (–) screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdrivers, numbers 1 and 2
•
Blank panels (if no component will be installed)
129