Configure the Wi-Fi Mini-PIM
To configure the Wi-Fi Mini-PIM:
1. Configure the Wi-Fi interface:
a. Configure an IP address for the Wi-Fi interface:
user@host# set interfaces wl-x/0/0 unit 0 family inet address ip-address
b. Configure the address pool. The DHCP address pool and the Wi-FI interface must be in the same
network.
user@host# set access address-assignment pool dhcp-pool family inet network ip-address
user@host# set access address-assignment pool dhcp-pool family inet range range low ip-address
user@host# set access address-assignment pool dhcp-pool family inet range range high ip-address
user@host# set access address-assignment pool dhcp-pool family inet dhcp-attributes router
ip-address
c. Enable DHCP server on the interface:
user@host# set system services dhcp-local-server group group interface wl-x/0/0.0
The eth0 interface on the Mini-PIM enables the DHCP client. If the DHCP server is enabled on the
wl interface, the server assigns an IP address to the eth0 interface. You can view the binding
information by issuing the show dhcp server binding command.
d. Assign the interface to a security zone:
user@host# set security zones security-zone zone interfaces wl-x/0/0.0
2. Configure the access point settings:
a. Configure the interface:
user@host# set wlan access-point name interface wl-x/0/0
b. Set the country code (applicable only for SRX-MP-WLAN-WW models):
user@host# set wlan access-point name access-point-options country country-code
NOTE: If you do not set the country code for the SRX-MP-WLAN-WW models,
the Mini-PIM considers the country code as US. You cannot set the country code
for the SRX-MP-WLAN-US and SRX-MP-WLAN-IL models.
c. Set the location:
user@host# set wlan access-point name location location
d. Commit the configuration:
117
To Next Page
Loading...
Need help?
General
