EasyManua.ls Logo

Juniper SRX300 Series - Wi-Fi Mini-Physical Interface Module

Juniper SRX300 Series
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Wireless Modem Network Info
Current Modem Status: Connected
Current Service Status: Normal
Current Service Type: PS
Current Service Mode: LTE
Current Band: B3
Network: UNICOM
Mobile Country Code (MCC): 460
Mobile Network Code (MNC): 1
Location Area Code (LAC): 65534
Routing Area Code (RAC): 0
Cell Identification: 4865903
Access Point Name (APN): ctnet
Public Land Mobile Network (PLMN): CHN-UNICOM
Physical Cell ID (PCI): 333
International Mobile Subscriber Identification (IMSI): **************
International Mobile Equipment Identification (IMEI/MEID): *************
Integrate Circuit Card Identity (ICCID): 89860114721100697502
Reference Signal Receiving Power (RSRP): -97
Reference Signal Receiving Quality (RSRQ): -16
Signal to Interference-plus-Noise Ratio (SiNR): 0
Signal Noise Ratio (SNR): 0
Energy per Chip to Interference (ECIO): 0
Wi-Fi Mini-Physical Interface Module
IN THIS SECTION
Wi-Fi Mini-Physical Interface Module Overview | 91
Wi-Fi Mini-PIM Hardware Specifications | 93
Channels and Frequencies Supported on the Wi-Fi Mini-PIM | 94
Country Codes and Regulatory Domains | 99
RF Specifications for the Wi-Fi Mini-PIM | 109
Installing the Wi-Fi Mini-PIM in an SRX Series Services Gateway | 111
Configuring the Wi-Fi Mini-PIM on an SRX Series Services Gateway | 113
Verify the Status of the Wi-Fi Mini-PIM | 120
Upgrading the Firmware on the Wi-Fi Mini-PIM | 122
90

Table of Contents

Other manuals for Juniper SRX300 Series

Related product manuals