Juniper SRX300 Series - Upgrading the Firmware on the Wi-Fi Mini-PIM

Table 62: Commands to Verify and Monitor the Status of the Wi-Fi Mini-PIM (continued)
PurposeCommand
VAP2:
SSID : 5g_vap2
MAC Address : 00:00:5e:00:53:12
Maximum Station : 100
Broadcast SSID : Enable
Station Isolation : Disable
Upload Limit : Disable
Download Limit : Disable
VLAN ID : 0
Station MAC Filter : Disable
Traffic Statistics:
Input Bytes : 0
Output Bytes : 0
Input Packets : 0
Output Packets : 0
Radio2:
VAP0:
SSID : 2.4g
MAC Address : 00:00:5e:00:53:56
Maximum Station : 127
Broadcast SSID : Enable
Station Isolation : Disable
Upload Limit : Disable
Download Limit : Disable
VLAN ID : 0
Station MAC Filter : Disable
Traffic Statistics:
Input Bytes : 10802142
Output Bytes : 6228524
Input Packets : 100266
Output Packets : 36413
Upgrading the Firmware on the Wi-Fi Mini-PIM
To upgrade the firmware on the Mini-PIM using the CLI:
122