•
Protocols=Allow All
d. Click OK to save changes, and select Commit>Commit to apply the configuration and other pending
changes.
4. To use the port on the Mini-PIM, you must also set security policies. Select the following settings:
a. Select Configure>Security>Security Policy
b. Select Global Options > Policy Options.
c. Set Policy Action: Default Policy Action=Permit-All
d. Click OK to save changes, and select Commit>Commit to apply the configuration and other pending
changes (if any).
For more information, in the J-Web interface, select Configure>Interfaces and click Help.
Using the CLI
To perform basic configuration of the 1-Port VDSL2 Annex A Mini-PIM and to configure network interfaces
for the services gateway with the CLI:
1. Verify that the 1-Port VDSL2 interface is installed on the device:
show chassis hardware
2. Verify the status of the interface:
show interfaces terse
3. Assign the port an IP address:
set interfaces pt-1/0/0 unit 0 family inet address interface address/destination prefix
4. Add or select a security zone; for example, Zone1:
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic system-services all
5. Add or select security zones for host inbound traffic options protocols:
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic protocols all
6. Set security policies:
set security policies default-policy permit-all
RELATED DOCUMENTATION
62
To Next Page
Loading...
Need help?
General
