Juniper SRX300 Series - 8-Port Gigabit Ethernet SFP XPIM; 8-Port Gigabit Ethernet SFP XPIM Overview

Maintaining the SRX Series Interface Modules | 129
8-Port Gigabit Ethernet SFP XPIM
IN THIS SECTION
8-Port Gigabit Ethernet SFP XPIM Overview | 63
8-Port Gigabit Ethernet SFP XPIM Components | 64
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications | 65
8-Port Gigabit Ethernet SFP XPIM LEDs | 65
8-Port Gigabit Ethernet SFP XPIM Supported Transceivers | 66
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications | 67
8-Port Gigabit Ethernet SFP XPIM Basic Configuration | 69
8-Port Gigabit Ethernet SFP XPIM Overview
The ports of the 8-Port Gigabit Ethernet small form-factor pluggable Gigabit-Backplane Physical Interface
Module (SFP XPIM) can be used for connecting to Ethernet WAN service as well as for local server
connectivity at Gigabit Ethernet speeds. The XPIM enables Layer 2 line-rate Gigabit switching and
system-processor dependent Layer 3 service with connection of up to eight SFP Gigabit Ethernet ports.
The 8-Port Gigabit Ethernet SFP XPIM complements the on-board 10/100/1000 Mbps Ethernet interfaces
with extended WAN connectivity. It supports a variety of transceivers. This XPIM can be used in copper
and optical environments to provide maximum flexibility when upgrading from an existing infrastructure
to Metro Ethernet.
The 8-Port Gigabit Ethernet XPIM can be installed in any GPIM slot on the SRX550 High Memory Services
Gateways.
Figure 8 on page 63 shows the front panel of the 8-Port Gigabit Ethernet SFP XPIM.
Figure 8: 8-Port Gigabit Ethernet SFP XPIM Front Panel
g021287
63