Juniper SRX300 Series Reference Guide

1-Port VDSL2 Annex A Mini-Physical Interface Module (SRX-MP-1VDSL2-R)
Basic Configuration
IN THIS SECTION
Using the J-Web Interface | 61
Using the CLI | 62
To enable the 1-Port VDSL2 Annex A Mini-Physical Interface Module (Mini-PIM) installed on the services
gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for
this using either the J-Web interface or the CLI.
Using the J-Web Interface
To perform basic configuration for the 1-Port VDSL2 (Annex A) Mini-Physical Interface Module (Mini-PIM)
and to configure network interfaces for the services gateway using the J-Web interface:
1. In the J-Web interface, select Configure>Interfaces.
The Interfaces page displays and lists the network interfaces present on the services gateway, along
with configuration information (if configured).
2. Select the interface name (pt-1/0/0) and click Add > Logical Interfaces. Enter the details and click OK.
To use the port on the Mini-PIM, assign an IP address to the port and assign it to a security zone, other
than the Null zone. If there are no security zones listed, proceed to the next step to add a security zone.
3. Add a security zone to the interface:
a. Select Configure>Security>Zones/Screens.
b. Add or select a security zone other than Null; for example, Trust. Assign the interface to the zone.
c. For Host Inbound Traffic-Zone, set the following:
•
System Services=Allow All
61

Juniper SRX300 Series Specifications

General

Memory	4 GB
CPU	Intel Atom
Storage	8 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% noncondensing