Juniper SRX300 Series - 8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications

Table 40: 8-Port Gigabit Ethernet SFP XPIM Supported Modules (continued)
CableConnector Type (SFP Transceiver)Juniper Product Number
LC1000BASE-BX10, at 10 km (TX 1310 nm / RX 1550
nm)
EX-SFP-GE10KT13R15
LC1000BASE-BX10, at 10 km (TX 1490 nm / RX 1310
nm)
EX-SFP-GE10KT14R13
LC1000BASE-BX10, at 10 km (TX 1550 nm / RX 1310
nm)
EX-SFP-GE10KT15R13
LC100Base-BX Fast Ethernet Optics, at 20 km (TX 1310
nm / RX 1550 nm)
EX-SFP-FE20KT13R15
LC100Base-BX Fast Ethernet Optics, at 20 km (TX 1550
nm / RX 1310 nm)
EX-SFP-FE20KT15R13
LC1000BASE-BX, at 40 km (TX 1310 nm / 1550 nm)EX-SFP-GE40KT13R15
LC1000BASE-BX, at 40 km (TX1550 nm / RX1310 nm)EX-SFP-GE40KT15R13
CAUTION: If you face a problem running a Juniper Networks device that uses a
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications
Table 41 on page 67 provides the network interface specifications of the 8-Port Gigabit Ethernet small
form-factor pluggable XPIM (SFP XPIM).
Table 41: 8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications
ValueNetwork Interface Specification
Full-duplex and half-duplexOperating modes
67