KEB F6 - Page 129

Parameter Descriptions
© 2024 KEB America, Inc.
129
For geared machines with an unknown ratio, the LN05 Estimated Gear Reduction
Ratio can be entered in LN02;  refer to LN05 for additional information. The gear
ratio can also be determined by counting the revolutions of the motor during one
revolution of the traction sheave.
LN03 Roping Ratio
The roping ratio, X:1.
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
1
4
-
-
1
Basic
LN04 Load
The load capacity of the elevator, in lbs or Kg, depending on US02 System Units (ft/min
or m/s).
This parameter has no function and is only used for reference.
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
13605
-
kg
0
Basic
0
30000
lb
-
0
LN05 Estimated Gear Reduction Ratio
This parameter can be used to estimate the gear ratio if it is not known.
After correctly entering values into LM02 Motor Speed, US06 Contract Speed, LN01
Traction Sheave Diameter, LN03 Roping Ratio, read this value and enter this value into
LN02 Gear Reduction Ratio.
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RO
RO
0
250
-
-
0
Basic