KEB F6 User Manual

Parameter Descriptions
© 2024 KEB America, Inc.
133
LS00 Zero Speed
Zero Speed Offset. When this parameter is set to a speed other than zero and only the
enable and direction signals have been sent to the drive (no speed command), the motor
will be run at the offset speed programmed in LS00. This function only applies to binary
and digital speed control modes.
Max. Value: 2.952755906 fpm
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
0.01
-
m/s
0
Basic
0
2.952755906
ft/min
-
0
LS01 Leveling Speed
During leveling speed, a higher selected speed will be ignored unless zero speed is
commanded beforehand.
Max. Value: 25 fpm*
*An upper limit of 59fpm can be achieved when LX50 Unlock LS01 is activated.
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
0.127
-
m/s
0.02
Basic
0
25
ft/min
-
3.937007874
LS02 High Speed
This speed setting uses the high speed profile settings LS20-25 and LS27 Correction
Distance.
The upper limit for parameters LS00-LS10 is clamped by US06: Contract Speed.
The High Speed must also be set when US04 Control Type = Bi-Polar Analog
Speed (3), Absolute Analog Speed (2), Serial Speed DIN66019 Service 49 (4),
Serial Speed DIN66019 Service 50 (5).
Max. Value: US06 Contract Speed
Run Profile: High Speed Profile LS20-27
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
8.125
-
m/s
0
Basic
0
1600
ft/min
-
0

KEB F6 Specifications

General

Category	Inverter
Protection Class	IP20
Communication Interfaces	PROFIBUS, CANopen, RS485
Operating Temperature	-10°C to +50°C
Series	F6
Output Frequency	0 Hz to 600 Hz
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit
Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m above sea level
Control Modes	Sensorless vector control
Storage Temperature	-25°C to +70°C