KEB F6 - Page 134

Parameter Descriptions
134
© 2024 KEB America, Inc.
LS03 Inspection Speed
This speed setting uses the inspection speed profile settings LS50-55. If the inspection
speed command is present when the drive is enabled, the inspection profile will be
loaded. During the inspection speed profile, all other speeds except leveling speed will be
ignored.
Max. Value: 150 fpm
Run Profile: Inspection Speed Profile LS50-55
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
0.63
-
m/s
0
Basic
0
150
ft/min
-
0
LS04 Correction Speed
Also known as High Leveling Speed. During correction speed, a higher selected speed
will be ignored unless zero speed is commanded beforehand.
If the LI60 (Special Speed Functions) input is turned on, the drive will allow the controller
to switch between inspection and correction speed commands (zero speed command not
required). This only applies when US04 Control Type = Binary Speed Control (1).
Max. Value: 50 fpm
Run Profile: Inspection Speed Profile LS50-55
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
0.254
-
m/s
0
Basic
0
50
ft/min
-
0
LS05 Intermediate Speed 1
This speed setting uses the One Floor Speed profile settings LS30-35 and LS37
Correction Distance.
Max. Value: US06 Contract Speed
Run Profile: One Floor Profile (Intermediate Speeds 1, 2) LS30-38
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
0
8.125
-
m/s
0
Basic
0
1600
ft/min
-
0