KEB F6 - Page 149

Parameter Descriptions
© 2024 KEB America, Inc.
149
LL05 SPI
Stationary Pole Identification. Learns the motor pole position (encoder position) without
movement, for synchronous motors.  Refer to Encoder Learn section, pg. 71 for
procedure.
If the encoder A/B channel phasing is subsequently swapped in LE03, the SPI
procedure will need to be performed again.
Motor
Type
Setting Options
NUM
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
Tune Activation
-
0
255
-
-
0
Basic
OFF
0
-
-
-
-
-
-
Start
1
Tune Active
2
Tune Complete
4
Tune Failed
8
Tune State
-
off
0
USER: Run empty car UP on
Inspection Speed
16
STATUS: Determining encoder
pole offset
32
USER: End the run
48
FAILURE: Speeds not correct,
verify encoder
PPR/Signal/Mounting
64
STATUS: Motor phasing incorrect,
swapping encoder phases, run the
car UP again
80
USER: Did the elevator travel UP?
96
STATUS: Reversing motor
direction, run the car UP again
112
FAILURE: Encoder error detected,
verify encoder
PPR/Signal/Mounting
128
FAILURE: Minimum measurement
speed not reached, increase
speed, run the car UP again
144
SUCCESS: SPI complete, do
Encoder Synchronization next
160
Cannot start tune because another
tune mode is already active
176
ERROR: Tune Motor with LL01 first
192