KEB F6 - Page 193

Parameter Descriptions
© 2024 KEB America, Inc.
193
LO25 Software Output
The Software output is an internal output which can be used to indicate the status of a
function through serial communication, i.e., when one of the process data are mapped to
DG11.
Motor Type
Setting Options
NUM
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
Output Function
-
0
17
-
-
17
Basic
OFF
0
-
-
-
-
-
-
Fault
1
Drive ready
2
Reserved
3
Reserved
4
At speed
5
High speed
6
Deceleration active
7
Speed for door pre-opening
8
Reserved
9
Motor Contactor Control
10
Motor overheat
11
Cabinet fan on
12
Condition 1
13
NTSD active
14
Reserved
15
Reserved
16
Brake transistor error
17
LO30 Data Value 1
When one of the output functions in LO05-
Value 1 is the value which will be evaluated against the parameter LO32 Comparison
Level 1 according to the operand LO31 Condition 1.
The setting for LO30 corresponds to the associated DG parameter.
• For example, when LO30 = 2, this corresponds to DG02 Inverter Status.
• 
Inverter State = 30; Error Motor Protection (EOH2).
Motor Type
Range
Units
Default
Pass
Level
Ind.
PM
Min.
Max.
Imp.
Met.
RW
RW
1
90
-
-
1
Basic