KEB F6 User Manual

Parameter Descriptions
© 2024 KEB America, Inc.
199
Description
Value
A.STOP overheat pow.mod
89
ABN.STOP external fault
90
no A. drive overheat
91
no A.STOP overheat int.
92
ABN.STOP bus
93
ABN.STOP prot. rot. for.
94
ABN.STOP prot. rot. rev.
95
ABN.STOP drive overheat
96
ABN.STOP motor protect.
97
no ABN.STOP overload
98
ABN.STOP overload
99
ABN.STOP overload 2
100
no ABN.STOP overload 2
101
ABN.STOP set
102
ABN.STOP bus synchron.
103
ABN.STOP soft.limit for.
104
ABN.STOP soft.limit rev.
105
ABN.STOP max. accelerat.
106
ABN.STOP speed ctrl. lim
107
ready for positioning
121
positioning active
122
position not accessible
123
prot. rot. for.
124
prot. rot. rev.
125
pos.not accessib.ignored
126
calc. motor data complete
127
reference found
128
Main contact failure
150
Brake switch failure
151
Speed following error
152
Speed selection error
153
NTS Input Failure
154
NTS Overspeed
155
NTS Input Failure
156
Analog Signal Failure
157
Unintended movement
158
Secure Fault Reset
159
ESD Input Failure
160
Direction Selection Failure
161
Drive Enable Switched OFF
162
ERROR! Fieldbus Watchdog
163
ERROR! Commutation position
164
ERROR! Excessive Acceleration
165
ERROR! Serial Command Speed
166
ERROR: Regen Fault
167
Description
Value
Rotor Learn Deviation ERROR
168
Rotor Learn COM ERROR
169
UPS Mode
170
Reduced torque
171
Emergency Profile
172
Emergency Generator Speed
173
Earthquake speed
174
Emergency Slowdown
175
No com to Enc. Card
200
Enc. Communication OK
201
Encoder not defined
202
No communication to enc.
206
inc. count deviation
207
Enc. ppr does not match LE01
208
Interface ID. is wrong
209
Encoder over temperature
213
Encoder over speed
214
Enc. supply volt. too low
215
Internal encoder error
216
Formatting encoder
217
New encoder identified
221
Undefined encoder error
222
Encoder interface busy
223
OL Warning Triggered
500
OL2 Warning Triggered
501
OH Warning Triggered
502
OHI Warning Triggered
503
dOH Warning Triggered
504
OH2 Warning Triggered
505
Watchdog Warning Triggered
506
Heartbeat Warning Triggered
507
ProgErr Warning Triggered
508
OS Warning Triggered
509
MaxAccDec Warning Triggered
510
SwSwitch Warning Triggered
511
SpeedDiff Warning Triggered
512
AnIn Warning Triggered
513
ENC-A Warning Triggered
514
ENC-B Warning Triggered
515
Uph Warning Triggered
516
Limit Switch Warning Triggered
517
Blockage Warning Triggered
518
Suppressed UP Warning Triggered
519
Suppressed PU Ready Warning
Triggered
520

KEB F6 Specifications

General

Category	Inverter
Protection Class	IP20
Communication Interfaces	PROFIBUS, CANopen, RS485
Operating Temperature	-10°C to +50°C
Series	F6
Output Frequency	0 Hz to 600 Hz
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit
Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m above sea level
Control Modes	Sensorless vector control
Storage Temperature	-25°C to +70°C