Keithley 2000 - Page 153

:PERiod
:APERture
:APERture?
:THReshold
:VOLTage
:RANGe <n>
:RANGe?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
Path to configure period.
Sets gate time for period measurements (0.01-1.0s).
Query period gate time.
Path to select the threshold voltage range:
Select threshold range (0 to 1010).
Query threshold range.
Specify reference (0 to 1).
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Specify measurement resolution (4 to 7).
Query resolution.
10
0
OFF
7
:DIODe
:CURRent
:RANGe
[:UPPer] <NRf>
[:UPPer]?
Paths to configure diode test:
Path to select range.
Select range (0 to 1e-3)
Query range.
1e-3
:CONTinuity
:THReshold <NRf>
:THReshold?
Path to configure continuity test:
Set threshold resistance (1 to 1000).
Query threshold resistance.
10
Note: REPeat is the *RST default and MOVing is the :SYSTem:PRESet default.
Table 5-6(cont.)
SENSe command summary
Command Description
Default
parameter
SCPI
SCPI Command Reference 5-15