Keyscan CA150 - Page 59

Keyscan Inc. A Member of the Kaba Group – CA150 Rev. B Installation Guide (07.15)
59
 Connect the Ethernet cable from the PoE power source – the network switch or the injector – into the
Ethernet terminal on the CA150 control board.
 Within 5 seconds of establishing the connection, the CA150 should receive power from the PoE source
and begin booting up. The system status LED illuminates in amber and the on-board piezo emits a
beep.
 Using a voltmeter, check the following terminals on the CA150 for +12V DC:
 Reader 1 – PWR RED
 Reader 2 – PWR RED
 POWER OUT + (TB6)
 DOOR output N/C or N/O (if set on POWERED)
 AUX output N/C or N/O (if set on POWERED)