Keysight Technologies B1505A

Keysight B1505A User’s Guide, Edition 12 3-47
Accessories
• Universal Socket Module (N1265A-011)
This is a blank module, kind of a do-it-yourself kit for supporting variety of
packaged devices. This module can be used by mounting your desired socket or
packaged device and making connections same as the N1265A-010 Inline
Package Socket Module.
To use this module, see the following simple instruction. For the component
locations and dimensions, see Figure 3-13. Also see “Inline Package Socket
Module (N1265A-010)” on page 3-45 to perform measurement.
Figure 3-13 Universal Socket Module
1. Prepare the following parts.
• blank board suitable for mounting the socket or packaged device
• screw M3, 4 ea., for fixing the blank board on the socket module
• wire, adequate length and quantity, for making connections
• hexlobe (torx type) screwdriver T-10
• socket, if you use, and packaged device under test (DUT)
2. Cut the blank board in 90 mm  81 mm square.
3. Make four screw holes on the board. The holes should be 6 mm inside from
the edge.
4. Fix the board to the blank module.
5. Remove the cover bottom of the blank module.
6. Mount the socket or DUT on the board and solder wire between its terminals
and the blank module terminals.
165 mm
165 mm
129 mm
160 mm
2
1
3
4
5
6
7
8
Collector / Drain
Emier / Source Base / Gate
N1265A Opt 011
Force Sense
Force Sense
Force Sense
Universal Socket Module
1
2
5
6
4
3
91 mm (Nut pitch: 78 mm)
(Nut pitch: 69 mm)
82 mm